1. Verify that your rack kit includes the following contents (see Figure 4-6):
v Packaged in plastic material:
– 2 rails (not shown)
– 2 mounting brackets (1)
v
Packaged in the small bag with no label:
– 1 T10 Torx wrench (5)
– 2 U-shaped anchors (4)
– 4 small screws for securing the anchors and brackets (6)
– 2 large screws to secure the mounting brackets to the rack (7)
v
Packaged in the small bag with ″Round Hole″ on the label: 9 screws to be
used on racks with round holes. (2)
v Packaged in the small bag with ″Square Hole″ on the label: 9 screws to be
used on racks with square holes. (3)
Note:
Eight screws are needed for the installation. One additional screw is
provided for security.
2. Determine the location in your rack for your library to be installed and, using a
pencil, mark the location on each vertical rail in your rack.
Note: A 2U library requires 2U (3.5 in.= two EIA) of rack space. A 4U library
requires 4U (7 in. = four EIA) of rack space
1
3
4
6
2
a77ug208
5
7
Figure 4-6. Rack Kit Mounting hardware
Chapter 4. Installation and Configuration 4-7
