![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/5/46/54678f55-6c96-499c-b826-cec484bd8db4/54678f55-6c96-499c-b826-cec484bd8db4-bg43.png)
10. Press the CANCEL button until the Home screen displays.
11. Press the CANCEL button to return to the home screen.
12. Power cycle the library to initialize your configuration.
Logging on to the Web User Interface
To complete the configuration of your library using the Web User Interface, follow
the steps below.
1. Return to the Home screen on the Operator Control Panel.
2. On your host computer, open Internet Explorer.
3. In the browser address field, enter your library’s IP Address. For DHCP, enter...
a. For DHCP, use the Operator Control Panel to determine the IP Address
assigned to your library. Navigate to Monitor → Library → Identity. Scroll
down to IP Address and make note of the address. Enter the IP Address in
your internet browser address field to access your library with the Web
User Interface.
b. For IPv4 or Dual Stack IPv4 + IPv6, enter your library’s static IP Address
using the 0.0.0.0 format (four octets).
c. For IPv6, enter your library’s static IP Address or Router Assigned IP
Address using the following format: http://[0:0:0:0:0:0:0:0]. To determine
your Router Assigned IP Address, navigate to Monitor → Library → Network
on the Operator Control Panel. For the IPv6 Router Assigned Addresses to
be displayed on the Operator Control Panel, the Network must be
configured to IPv6 Only and the Stateless Autoconfig on the must be set to
ON.
4.
When the login screen appears,
v Select admin for a User ID
v Enter secure for a Password
Verifying/Updating Firmware
It is important to run the latest level of firmware. To ensure that you are running
the latest levels of library and drive firmware, complete this procedure.
1. Verify the levels of library and drive firmware currently installed on your
library.
a. Expand Monitor Library in the left navigation pane of the Web User
Interface.
b. Click Library Identity and make note of the Firmware revision.
c. Click Drive Identity and make note of the Firmware revision.
d. Log out of the Web User Interface.
2. Download the latest library and drive firmware from http://support.dell.com.
a77ug070
Figure 4-18. Log in screen on the Web User Interface
Chapter 4. Installation and Configuration 4-17