Garmin 340c Manual

A SERVICE OF

next previous

 Fishnder 340C Owner’s Manual

InstAllIng the fIshfInder 340c > MountIng the fIshfInder

Mounting the Fishnder

There are two possible installation methods for your Fishnder:

• You can mount the Fishnder onto a bracket that attaches to

the console or overhead.

• You can ush mount the Fishnder into a at panel.

Surface Mounting the Fishnder

The Fishnder 340C’s compact, waterproof case is suitable for

mounting in exposed locations or at the nav station. The Fishnder

comes with a tilt/swivel mounting bracket that can be used for

console or overhead mounting.

Mounting the Bracket Assembly

—drill, screwdriver (Phillips or standard), and

one of the following:

• Three #8 (4 mm) pan-head machine bolts with matching nuts

and washers and a 5/32" (5 mm) drill bit.

• Three #8 pan-head self-tapping screws and a 1/16

" drill bit

for drilling starter holes.

Use a pan-head machine bolt or self-tapping screw to secure the

swivel base. If you use a screw with a countersunk head, you risk

damaging the mounting bracket.

OK

To mount the bracket assembly:

1. Using the swivel base as a template, mark the location of

the three holes that secure the bracket to the mounting

surface.

2. Drill the mounting holes.

• Ifyousecurethebasewithmachinebolts,drillthree

5/32"(5mm)holesatthelocationsyoumarked.

• Ifyousecurethebasewithself-tappingscrews,drill

starterholesatthelocationsyoumarked.Donotmake

thestarterholesdeeperthanhalfthescrewlength.

3. Secure the swivel base with three bolts or screws. DO NOT

OVERTIGHTEN.

4. Placetheswivelmountbracketovertheswivelbaseand

secure it with the short knob.