Garmin 340c Manual

A SERVICE OF

next previous

 Fishnder 340C Owner’s Manual

InstAllIng the fIshfInder 340c > MountIng the fIshfInder

To ush mount the Fishnder 340C:

1. TrimtheFlushMountTemplate,andtapeittothechosen

location.

2. Usingacenterpunch,indentthecenterofeachmounting

hole location.

3. Usingan1/8"(3mm)drillbit,drillthefourmountingholes.

4. Usinga3/8"(6mm)drillbit,drillaholeforalocationto

begin cutting the mounting surface.

5. Usingthejigsaw,cutthemountingsurfacealongtheinside

ofthedashedlineindicatedonthetemplate.Beverycareful

when cutting this hole, there is only a small amount of

clearancebetweentheFishnderandthemountingholes.

Youcancutslightlyinsidetheindicatedlineandthensand

orlethepanel,asneeded,toobtainthebestt.

6. InstallthefourmountingstudsintotheFishnderby

screwingtheshortersectionintothebackoftheFishnder.

Use a 1/16" (2 mm) Allen wrench to tighten the mounting

studsuntilthestopcontactsthecase.Becarefulnotto

overtighten,becausethiscandamagethemountingstud!

Thestudshaveareusablethread-lockingpatchpre-applied

from the factory.

7. PlacetheFishnderintothecutoutinthemountingsurface.

8. Placewashersoverthemountingstuds,andthenthread

ononehexnutpermountingstud.Tightenallfouruntilthe

Fishnderissnugagainstthemountingsurface.Installand

tightenthesecondhexnutonallfourmountingstudstolock

therstoneintoplace.

Mounting Surface (Back View)

Hex nut

Washer

Studs