Fishnder 340C Owner’s Manual 3
usIng the fIshfInder 340c > PAusIng A sonAr or flAsher PAge
—the time of day, shown using your selected time format.
—an alarm that counts down or up in the increments that
you set in the Alarms System sub tab.
—the degrees that you must turn left or right to make your
direction of travel match your bearing. Steer left (L) or right (R)
until this reads to go directly to your destination.
(velocity made good)—the rate of closure to a destination
based on your current speed and course.
—the current battery voltage input.
(water temperature)—the water temperature at the
transducer.
(crosstrack error)—how far off the chosen course you are,
measured by your selected distance units. This indicates if you are
to the left or right of the course.
Pausing a Sonar or Flasher Page
Use a paused screen to take a better look at sonar returns. The
depth continues to update while the page is paused, but the
Fishnder does not show any new sonar data until the Sonar Page
resumes scrolling. You might see a discontinuity from where the
sonar information stops to where it starts again when you resume
scrolling the screen.
To pause and unpause the Sonar or Flasher Page:
From the Sonar or Flasher Page, press PAUSE to stop the
scrolling. Press PAUSE again (or QUIT) to resume scrolling.
