Garmin 340c Manual

A SERVICE OF

next previous

0 Fishnder 340C Owner’s Manual

InstAllIng the fIshfInder 340c > MountIng the trAnsducer

Mounting the Transducer on a Trolling Motor

(Dual Beam Only)

To mount the transducer on a trolling motor:

1. Slidethelargecabletiethroughtheslotonthetransducer

mount (see the illustration on page 9)withtheridgesofthe

bandfacingupuntilequallengthsextendonbothsidesof

the mount. (NOTE:Forcoldwater,orheavytimberordebris

areas,ametal4-5"wormgearclampisrecommended.)

2. Positionthemountgasketonthecurvedtopofthe

transducermount.

Cable tie

Front of the transducer

3. Placethetransducerassemblyagainstthemotorbodyof

thetrollingmotor,withthefrontofthetransducerpointed

away from the trolling motor propeller.

4. Wrapthetwoendsofthecabletiearoundthemotorbody.

Placethepointedendofthecabletiethroughthefastener

holeontheoppositeendandpullitthroughuntilitissnug

but not tight. (The cable tie clicks when you pull it.)

5. Positionthetransducersothatitisparallelwiththebottom

wheninuse,andmakesurethegasketisalignedproperly.

Pullthecabletieenduntiltight.Trimofftheexcessif

necessary.Tightenthe10-32lockingnutuntilittouchesthe

mountingbracket,andthentighten1/4turnmore.(Donot

overtighten.)

6. Routethe30-foot(9m)transducercableusingthesupplied

cable ties to secure the cable to the motor shaft. You can

lltheforward-facingportion(exceptthecabletiepocket)

ofthetransducermountwithsealanttoavoidaccumulating

debris.