10 Suspend /Resume Button
HX1 Reference Guide E-EQ-HX1RG-C-ARC
Suspend /Resume Button
The Suspend /Resume button can be used to suspend or resume the HX1. It can also be used to
reset the HX1.
• When the HX1 is on, pressing and releasing the Suspend / Resume button places the
HX1 in Suspend mode. In approximately 1.5 seconds, the Power LED goes out
indicating the HX1 is in Suspend mode.
• When the HX1 is in Suspend mode, pressing and releasing the Suspend / Resume
button resumes the HX1.
• Pressing and holding the Suspend / Resume button for more than eight seconds
resets the HX1.
Power LED
The Power LED is built into the Suspend / Resume switch. The color and behavior of the
POWER LED indicated the status of the HX1:
• Green light, blinking once every three seconds – Indicated the HX1 is receiving a
software upgrade.
• Green light, blinking once per second – Indicated the HX1 has started the browser.
• Green light, on solid – The green light remains on solid for approximately 30
seconds after the HX1 has booted. Once the browser has loaded the light blinks
once per second.
• Red light, blinking rapidly – Indicates an error has occurred during the system
install.
• No lights – Indicated the HX1 is either in Suspend mode or has no battery power.
• Alternate Red and Green blinking light – Indicates the HX1 is out of range.
Entering Data
All data is entered into the HX1 by speaking into the headset’s microphone when prompted.
The HX1 is configured remotely using a PC and ActiveSync. Please refer to Chapter 3, “System
Configuration” for more information.
Voice software installed on the HX1 may provide additional configuration options. Please refer to
documentation for your voice software for information.
