Chapter 31 Maintenance
GS1900 Series User’s Guide
217
5. Click Apply to perform the ping test.
OR
Click Cancel to discard the changes.
The test results are displayed in Results.
31.7.4 Trace Route
Click Maintenance > Diagnostics > Trace in the navigation panel to open this screen. Use this
screen to print the route that IP packets take to a network host.
Figure 200 Maintenance > Diagnostics > Trace
The following table describes the labels in Trace Route.
Follow the steps to perform a trace route.
1. In IP Address, enter the IPv6 address.
2. In Hops, enter the number of hops.
3. Click Apply to perform the test.
OR
Click Cancel to discard the changes.
The test results are displayed in Result.
Table 181 Maintenance > Diagnostics > Trace
LABEL DESCRIPTION
IP Addres Enter the address of the target host server.
Hops Enter the maximum number of time-to-live or hops used in outgoing probe packets. The
range is 2 to 255 packets; the default is 30 hops.
