Filter
Top Products
Viewing measurements on the display
Locking or securing your dosimeter during run
053-644, Rev E Page 39 eg4 & eg3
39
The up/down arrows on the keypad of the dosimeter enable you to move through the
various measurements. For specific information on the views of the Edge, please see
“Views on the Edge”, page 18).
Viewing measurements
1. Press the or arrows. This will move you through the views on the display.
NOTE: If you enabled only one measurement to appear on the display, when you
press the up/down arrows it will not show any other measurement values. (To enable
additional measurement settings, see the “Edge Display Screen”.)
Figure 4-9: Measurement view on the Edge
As explained previously under DMS set-up parameters, the security or lock feature is
designed to lock the meter during run to ensure the study will not be stopped unless the
lock feature is disabled. (Setting this feature is programmed via DMS. Please see “Security
Setting”, page 27 for more details.)
Measurement views
on the Edge