Filter
Top Products
46 Technical Support
LED indicator: disable/enable
053-644, Rev E Page 46 eg4 & eg3
Technical Support
Some users may prefer to turn off the LED indicator.
To disable this feature, open QSP-II and select the Setup button. On the
dosimeter tab, under Dose% indicator LED uncheck the following:
Alarm enable: Will disable the flashing red LED when the threshold entered
exceeds the designated value during run mode. (If checked, red LED will flash.)
Heartbeat enable: Will disable the flashing green LED the dosimeter is running.
(If checked, a green LED will not flash.)
NOTE: For more information, see section on Dosimeter Settings, page 25.
CHAPTER
6
Alarm Enable