Filter
Top Products
48 Technical Support
Hard Hat Attachment Kit
053-644, Rev E Page 48 eg4 & eg3
The following instructions explain how to assemble and attach the hard hat kit to a
standard hard hat.
1. Using a 3/32” hex wrench, twist the top shoulder bolt counterclockwise to loosen and remove
the bolt and the clip. Also, remove the bottom clip with the hex wrench. Once the bottom clip
is removed, place the shoulder bolt back into its place and tighten back up with the hex
wrench.
2. Place the epaulette mount (see “A” above) into the top bracket of the Edge. Then slide the bolt
into place and tighten with a hex wrench. Then, the epaulette mount snaps onto the bottom
shoulder bolt.
3. Slide the two prongs of the hard hat mount (see “B” above) underneath the epaulette mount
(see “A above) until it clicks into place.
4. Taking the Edge with the assembled hard hat attachments, slide into the side of hard hat. It will
fit snuggly into the hard hat opening.
Shoulder bolt
Hex wrench
Epaulette
Shoulder bolt
Hard hat mount
attachment (The two
prongs slide into the
bottom cavity.)
Slide the two-sided prongs into
the hard-hat opening.
A
B
Hard Hat Attachment kit
A. Epaulette mount
B. Hard hat mount