Filter
Top Products
2-12
Catalyst Switch Module 3110G, 3110X, and 3012 for IBM BladeCenter Hardware Installation Guide
OL-12192-01
Chapter 2 Switch Module Installation
Installing Devices in the 10-Gigabit Ethernet Slot
Caution Verify the correct orientation of your module before inserting it into the slot. Incorrect insertion can
damage the module.
Step 5 Slide the transceiver module into the opening until the back of the module faceplate is flush with the
switch module faceplate.
Figure 2-7 Installing an X2 Transceiver Module
Removing a Module
To remove an X2 transceiver module, follow these steps:
Step 1 Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface.
Step 2 Disconnect the cables from the module. For fiber-optic modules, install the optical bore dust plugs.
Step 3 Carefully pull on the X2 module sleeve to disengage it from the slot. Grasp the edges of the module, and
carefully slide it out of the slot.
Step 4 Reinstall a replacement module or the module slot cover in the 10-Gigabit Ethernet slot.
Step 5 Place the module in an antistatic bag or other protective environment.
X
2
C
O
N
S
O
L
E
M
O
D
E
M
B
R
M
S
T
!
1 ST
A
C
K 2
201899