Filter
Top Products
Parameter Description
Enclose the name of the new repository virtual disk
in parenthesis ( ).
Autoconfigure Storage Array
Description
This command automatically configures a storage array. Before entering the autoConfigure
storageArray command, run the show storageArray autoConfiguration command. The show
storageArray autoConfiguration
command returns configuration information in the form of a list
of valid physical disk types, RAID levels, virtual disk information, and hot spare information. (This list
corresponds to the parameters for the autoConfigure storageArray command.)
The RAID controller modules audit the storage array and then determine the highest RAID level that the
storage array can support and the most efficient virtual disk definition for the RAID level. If the
configuration described by the returned list is acceptable, enter the autoConfigure storageArray
command without any parameters. To modify the configuration, change a single parameter or all of the
parameters to meet your configuration requirements. After entering the autoConfigure
storageArray command, the RAID controller modules set up the storage array using either the default
parameters or those you selected.
Syntax
autoConfigure storageArray [physicalDiskType=(SAS)] [raidLevel=(0 | 1 | 5 | 6)]
[diskGroupWidth=numberOfPhysicalDisks] [diskGroupCount=numberOfDiskGroups]
[virtualDisksPerGroupCount=numberOfVirtualDisksPerGroup]
[hotSpareCount=numberOfHotSpares] [segmentSize=segmentSizeValue]
[cacheReadPrefetch=(TRUE | FALSE)] [readAheadMultiplier=multiplierValue]
[securityType=(none | capable | enabled)] [dataAssurance=(none | enabled)]
Parameters
Parameter Description
physicalDiskType
Type of physical disks to use for the storage array.
Valid physical disk type is Serial Attached SCSI
(SAS). This parameter is not required if only one
type of physical disk is in the storage array.
raidLevel
RAID level of the disk group that contains the
physical disks in the storage array. Valid RAID levels
are 0, 1, 5 or 6.
diskGroupWidth
Number of physical disks in a disk group in the
storage array. For information about the number of
physical disks that you can use in a disk group, see
Enclosure Loss Protection.
diskGroupCount
Number of disk groups in the storage array. Use
integer values.
141