Filter
Top Products
Parameters
Parameter Description
source
Name of an existing virtual disk to use as the
source virtual disk. You must put quotation marks ("
") around the source virtual disk name.
NOTE: You can use any combination of
alphanumeric characters, hyphens, and
underscores for the names. Command names
can have a maximum of 30 characters. If you
exceed the maximum character limit, replace
square brackets ([ ]) with angle brackets (< >)
to overcome this limitation.
target
Name of an existing virtual disk to use as the target
virtual disk. You must put quotation marks (" ")
around the target virtual disk name.
NOTE: You can use any combination of
alphanumeric characters, hyphens, and
underscores for the names. Command names
can have a maximum of 30 characters. If you
exceed the maximum character limit, replace
square brackets ([ ]) with angle brackets (< >)
to overcome this limitation.
copyPriority
Specifies the priority that a virtual disk copy has
relative to host I/O activity. Valid entries are
highest, high, medium, low, or lowest.
NOTE: CopyPriority defines the amount of
system resources used to copy the data
between the source virtual disk and target
virtual disk of a virtual disk-copy pair. If you
select the highest priority level, the virtual disk
copy uses the most system resources to
perform virtual disk copy, which decreases
performance for host data transfers.
targetReadOnlyEnabled
Specifies whether the target virtual disk is write
enabled or read only. To be able to write to the
target virtual disk, set this parameter to FALSE. To
prevent writing to the target virtual disk, set this
parameter to TRUE.
copyType
Creates a virtual disk copy with or a snapshot
(legacy). Creating a virtual disk copy with a
snapshot (legacy) enables you to continue to write
to the source virtual disk while creating the virtual
disk copy. To create a virtual disk copy with a
202