Filter
Top Products
Page Up RotoKey Counter Clockwise
Page Down RotoKey Clockwise
Enter Push on RotoKey
End Power/Brill
Note: The USB port can also be used to load charts on the MFDBB (using a USB flash
Drive or a SD-Card to USB adapter). Due to the USB speed limitation (USB ver. 1.0)
this is not possible on the MFD8/12
2.9.2. Audio
Audio In and Audio out are reserved for future Development.
2.10. MFD8/12 Video, USB and Audio Connection
The DVI, USB, Analog Video Input and Audio In/Out ports are behind the connector
cover on the rear panel. To access to the ports and connect the cables, please refer to
the instructions below. Note that these connection points require an optional waterproof
connector boot if necessary. These connection points are not a waterproof design
without this option. Any water egress in this area will not be covered by the limited
warranty.
Note: The Waterproof Connector Boot is only required if the DVI, USB or Audio
connections are used and waterproofing is necessary for the MFD’s location.
2.10.1. Waterproof Connection
Waterproof connections for the DVI, USB, Analog Video Input and Audio I/O ports
require the optional connector boot (Type: OP19-7, PN: 001-028-090).
40