Filter
Top Products
3.2. Master Setting and initial configuration
- Press the power switch of the MFD you want to designate as Master to power it ON.
After few minutes, the Installation Wizard starts.
Note: The start up time of NavNet3D will be shorter once the system is fully configured.
- The system will search for sensors on the network. At this time you can skip the
search since no master is configured yet. Press on the “Skip” button
- If the MFD has factory default setting, the language selection screen appears. The
default language is English. Use the Cursor Pad and the center click (or the USB mouse
for the MFDBB) then click on “Next:
- On the Master Selection window that just appears, select Master = ON and press
“Save and Exit”
- Wait for the MFD to completely turn OFF (the MFDBB will restart then power off, be
patient!)
47