Filter
Top Products
satellites) in two digits.
INIT. Position Set initial latitude/longitude position for cold start.
ANT. Position Enter the GPS antenna positioning bow-stern and port-starboard position.
ANT. Height Enter the height of the GPS antenna unit above sea surface.
Rx Mode
Choose position fixing method: 2D (three satellites in view), 2D/3D (three or four
satellites in view whichever is greater).
WAAS Mode Select ON to use the WAAS mode.
WAAS Search
WAAS satellite can be searched automatically or manually. For manual search, enter
appropriate WAAS satellite number.
WAAS Alarm
When the WAAS signal is lost, the audible alarm sounds one of two ways. On: Alarm
sounds continuously until the WAAS positioning mode is available again or the alarm is
acknowledged (by key operation). Off: Alarm sounds three times.
IMPORTANT: After configuring any NMEA0183 Input Port Sensors on the Master MFD,
you must REPEAT THIS PROCEDURE on any other Slave MFDs in the network where
you have connected NMEA0183 Input Sensors!! If this is not done, the sensors will not
be available for selection as a Primary System Data Source in the Global Settings Tab.
-Click “Next” to continue the configuration
3.3.4. Analog Video
The Analog Video input can be renamed in this page. These names will be used by the
RotoKey and for the Video ID in the main interface.
On the MFDBB, four Analog Video inputs are available and can be either set to NTSC
or PAL format.
54