Filter
Top Products
6.3. Configuring AXIS IP Cameras
6.3.1. Introduction:
As of April 2009, the following MPEG-4 capable AXIS IP cameras are compatible with
NN3D: 207 / 211 / 212PTZ / 216FD /215PTZ / 225FD / 233D
In order to view and control Axis IP Cameras from an MFD in a Navnet 3D network, it is
first necessary to assign the IP Address of the AXIS IP Camera. This procedure will
require a Windows PC connected via Ethernet to the AXIS IP Camera(s). Pre-wiring
and installing the cameras on the vessel first is recommended so that all AXIS IP
cameras can be networked to the PC through a Hub and can be configured at the same
time. It will be necessary to setup the IP Address of the PC and use the AXIS IP Utility
Program (Provided with the Camera) to configure the Camera’s IP Address.
6.3.2. Setting the IP of the computer
Go to “Start” and select “Control Panel”
Open “Network Connections”
Right Click on “Local Area Connection” and select “Properties”
79