Filter
Top Products
3.4.3. IP Camera
You can assign names to each connected IP Camera. These names will be used by the
RotoKey and for the Video ID in the main interface.
Note: If the IP camera selection is unavailable, make sure that it has a correct IP
address (Refer to the Appendix “Configuring AXIS IP Camera”)
3.4.4. Primary Data Source selection
IMPORTANT: As explained in the “NMEA0183” p.47, if you have NMEA0183 sensors
connected to the input ports of MFD(s) on the network, you first need to configure the
“Own” settings for each MFD(s) before being able to select the corresponding
instruments as a data source.
Select the “Data Source” Tab. This tab allows you to select the Primary System Data
Source for various data types used by the Navnet 3D Network. Make sure to press the
“Refresh” button (on the lower right corner) before configuring the source to make sure
that all the source are scanned and available in each pop-up menu.
57