Filter
Top Products
5) When the MFDBB restarts, you can release the ESC key. After approximately 1-
2 minutes the MFDBB will power OFF completely
6) Re-connect the network and NMEA devices and power ON the MFDBB again.
The Installation Wizard will start with the default factory settings.
6.2.2. MFD8/12
1) Disconnect any network device
2) Disconnect any NMEA0183 Instruments
3) If the MFD8/12 is ON, power it OFF by pressing the “Power” key for more than 5
sec.
4) Press and Hold the [CANCEL] key
5) Start the MFD and continue to press the [CANCEL] key
6) The Cursor will appear, continue to hold the [CANCEL] key until the Installation
Wizard appears (approximately 1-2 minutes)
7) The MFD8/12 will not shut OFF (unlike the MFDBB) but the Installation Wizard
should appear with the language selection (confirming the Master Reset)
78