Filter
Top Products
page | 4
Installation
Getting Started
Connection Instructions
1. Connect an Ethernet cable between the IP-based control device and the IP control
port on the IP to 2 x RS-232 Converter.
An Ethernet switch can also exist between the IP to 2 x RS-232 Converter and the
IP-based control device (see Sample Wiring Diagram below).
2. Connect an RS-232 device to each of the RS-232 ports (RS-232 1 and RS-232 2) on
the IP to 2 x RS-232 Converter.
3. Connect the included 5V DC locking power supply to the 5V DC power receptacle on
the IP to 2 x RS-232 Converter. Do not overtighten the locking power connectors.
4. Connect the AC power cord from the power supply to an available electrical outlet.
Sample Wiring Diagram
EXT-IP-2-RS2322
DB-9 CABLE
RS-232-enabled
Device
CAT-5 CABLE
IP-based Automation
Control Device
Ethernet Switch
EXT-IP-2-RS2322
RS-232-enabled
Device