Filter
Top Products
page | 23
Commands
#set_send_time_out
Sets the time-out value for sending data collected from a device to the control system in
Bridging Mode when a Start Delimiter and End Delimiter have been set. If no data has been
collected for the specied time, the data is sent without waiting for the End Delimiter.
Syntax
#set_send_time_out param1
Parameters
param1 Serial port [1 ... 2]
param2 Time out (ms) [0 ... 255]
Example
#set_send_time_out 1 30
UART 1 bridging sent Time Out is set to 30 ms
Related Commands
#set_add_delim
#set_end_del
#set_serial_mode
#set_start_del
Advanced Operation