Filter
Top Products
Setup
LubricationLubrication
Lubrication
SystemSystem
System
SetupSetup
Setup
ComponentComponent
Component
AA
A
(ISO)(ISO)
(ISO)
Pump:Pump:
Pump:
Fill ISO lube reservoir
(LR) with Graco Throat Seal Liquid (TSL), part
206995 (supplied).
1. Lift the lubricant reservoir (LR) out of the bracket
(RB) and remove the container from the cap.
2. Fill with fresh lubricant. Thread the reservoir onto
the cap assembly and place it in the bracket (RB).
3. Push the larger diameter supply tube (ST)
approximately 1/3 of the way into the reservoir.
4. Push the smaller diameter return tube (RT) into
the reservoir until it reaches the bottom.
NOTE:NOTE:
NOTE:
The return (RT) must reach the bottom of
the reservoir to ensure that isocyanate crystals
will settle to the bottom and not be siphoned into
the supply tube (ST) and returned to the pump.
5. The lubrication is ready for operation. No priming
is required.
InstallInstall
Install
FluidFluid
Fluid
TemperatureTemperature
Temperature
SensorSensor
Sensor
The Fluid Temperature Sensor (FTS) is supplied.
Install FTS between main hose and whip hose (see
Related Manuals, page 16).
InstallInstall
Install
HeatedHeated
Heated
HoseHose
Hose
toto
to
ProportionerProportioner
Proportioner
1. Remove cover (CV).
2. Route heated hose wires (HW) through strain
relief (SR) and install wires into the open screw
terminals on the terminal block (TB). Torque to
35 in-lb (3.95 N•m).
3. Reinstall cover (CV).
334945B31