Filter
Top Products
Standby
StandbyStandby
Standby
If you stop spraying for a period of time, the unit will
enter standby by shutting down the electric motor
and hydraulic pump, to reduce equipment wear and
minimize heat buildup. The pump icon on the ADM
Home screen will ash when in standby.
NOTE:NOTE:
NOTE:
The A, B, and Hose heat zones will not shut
off during standby.
To restart, spray off target for two seconds. The
system will sense the pressure drop and the motor
will ramp up to full speed in a few seconds.
NOTE:NOTE:
NOTE:
This feature is disabled from the factory.
To activate or deactivate standby:
1. Enter setup mode by pressing on the ADM.
2. Go to screen System 3 and select to
enter
the page for editing.
3. Select the “Standby Idle Time” drop down using
and the arrow keys. Select the desired delay
using
and the arrow keys. Press enter to
select the desired value.
4. Exit the page and return to run mode by pressing
, then .
334945B53