Filter
Top Products
Startup
StartupStartup
Startup
To prevent serious injury, only operate Reactor with
all covers and shrouds in place.
NOTICENOTICE
NOTICE
Proper system setup, startup, and shutdown
procedures are critical to electrical equipment
reliability. The following procedures ensure steady
voltage. Failure to follow these procedures will
cause voltage uctuations that can damage
electrical equipment and void the warranty.
1. CheckCheck
Check
uiduid
uid
inletinlet
inlet
lterlter
lter
screens.screens.
screens.
Before daily startup, ensure that the
uid inlet screens are clean. See
Flush Inlet Strainer Screen, page 58
2. CheckCheck
Check
ISOISO
ISO
lubricationlubrication
lubrication
reservoir.reservoir.
reservoir.
Check level and condition of ISO lube daily. See
Pump Lubrication System, page 59.
3. Use A and B Drum Level Sticks (24M174) to
measure the material level in each drum. If
needed, the level can be entered and tracked in
the ADM. See Advanced Setup Screens, page 35.
4. CheckCheck
Check
generatorgenerator
generator
fuelfuel
fuel
level.level.
level.
NOTICENOTICE
NOTICE
Running out of fuel will cause voltage
uctuations that can damage electrical
equipment and void the warranty. Do not run
out of fuel.
5. ConrmConrm
Conrm
mainmain
main
powerpower
power
switchswitch
switch
isis
is
OFFOFF
OFF
beforebefore
before
startingstarting
starting
generator.generator.
generator.
6. Ensure the main breaker on the generator is in
the off position.
7. Start the generator. Allow it to reach full operating
temperature.
8. TurnTurn
Turn
mainmain
main
powerpower
power
switchswitch
switch
ON.ON.
ON.
The ADM will display the following screen until
communication and initialization is complete.
44
334945B