Filter
Top Products
Battery
Connect or Remove the Battery Pack
The MX3Plus will not function unless the battery pack is in place and securely latched.
Be sure to place the unit in Suspend Mode before removing the battery. Failing to properly place the device in Suspend mode
will result in a loss of all unsaved data.
The main battery is located in a compartment on the back of the unit. The battery case serves as the back cover for the battery
well of the MX3Plus.
An MX3Plus will retain data, while the main battery is removed and replaced with a fully charged main battery, for 5 minutes.
Important: When the internal battery power is Low or Very Low connect the AC adapter to the MX3Plus before replacing the
main battery.
Note: The battery should not be replaced in a dirty, harsh or hazardous environment. When the battery is not connected to
the MX3Plus, any dust or moisture that enters the battery well or connector may transfer to the battery/well terminals,
potentially causing damage.
Warning. Only useHoneywell batteries as replacements:MX3A378BATT/158224-0001
Insert/Replace Battery
To insert the main battery, complete the following steps:
1. Place the battery in the compartment, making sure the side of the battery with six contacts matches up with the battery
contacts in the battery well.Do not slide the battery sideways into the battery well.
2. Push down on the battery until the retaining clip clicks into place.
The MX3Plus draws power from the battery immediately upon successful connection.
Note: Do not cover the vent aperture in the battery well (located in the left side of the battery well) with anything other than
the main battery.
Check battery status by tapping the Start > Settings > Control Panel > Battery icon. Main battery level, internal battery
level, status and other details are displayed.
2-2