Filter
Top Products
MERLIN LEGEND Communications System Release 7.0
Pocket Reference
555-670-116
Issue 1
April 1999
118
Reference Documents
Maintenance Error Codes
—Continued
Technical Addendum
Error
Code Description Action
6C10 BRI NET INV 2B+D LB ACT:
Service on link has been lost.
Usually none; link should return
to normal once test is
completed. If problem persists,
contact NSAC Tier III.
6C11 BRI NET INV B1 LB ACT:
Service on link has been lost.
Usually none; link should return
to normal once test is
completed. If problem persists,
contact NSAC Tier III.
6C12 BRI NET INV B2 LB ACT:
Service on link has been lost.
Usually none; link should return
to normal once test is
completed. If problem persists,
contact NSAC Tier III.
6C13 BRI NET INV IL LB ACT:
Service on link has been lost.
Usually none; link should return
to normal once test is
completed. If problem persists,
contact NSAC Tier III.
6C14 BRI NET INV QM LB ACT:
Service on link has been lost.
Usually none; link should return
to normal once test is
completed. If problem persists,
contact NSAC Tier III.
7001 PRI SVC AUDIT TIMEOUT:
Check PRI facility and report to
service provider; otherwise, no
action is needed. If problem
persists, contact NSAC Tier III.
7002 PRI SVC STATE
INCONSIST:
Check PRI facility and report to
service provider; otherwise, no
action is needed. If problem
persists, contact NSAC Tier III.
7003 PRI D-CHNL INOPERATIVE:
Check PRI facility and report to
service provider; otherwise, no
action is needed. If problem
persists, contact NSAC Tier III.
7004 PRI B-CHNL NOT
RELEASED:
Check PRI facility and report to
service provider; otherwise, no
action is needed. If problem
persists, contact NSAC Tier III.
7005 PRI B-CH GROUP
INCONSIST:
Check PRI facility and report to
service provider; otherwise, no
action is needed. If problem
persists, contact NSAC Tier III.
7006 PRI PROTOCOL MISMATCH:
A mismatch in the protocol being
supplied versus the protocol
expected by MERLIN LEGEND.
Inform the service provider to
change the administration for
this circuit. After the service
provider restarts the circuit,
verify that all alarms for this slot
are cleared.