Filter
Top Products
4
PART 2 HARDWARE
2.1 Mounting
Position unit where required. Mark and drill
holes as required.
If unit is to be mounted on a flat
surface, you may take the bottom
rubber feet off the unit.
It is recommended that you
ground your unit by wrapping a
wire around the mounting tab
screw and tightening a lock
washer so that it embeds itself
into the metal of the mounting tab.
Or
by connecting a wire to the
Return/Ground position of the
relay connector, see Figure 2.7.
1
4
3
2
OFF
ON
1
4
3
2
OFF
ON
9-12 Vdc
0.25 [6.4]
0.25 [6.4]
1.78 [45.2]
2.42 [61.6]
3.56 [90.3] 2.00 [50.8]
9.15 [232.3]
0.14 [3.6]
0.30 [7.7]
3.05 [77.5]
3.55 [90.2]
0.12 [3.0]
1.44 [36.6]
Figure 2.1 Mounting
Figure 2.2 DIP Switches
2.2 DIP Switches
The iServer is shipped with all DIP
switches in "OFF" position.
DIP
Switch Usage
1) N/C - not used
2) To change to default
factory settings
3) To enable/disable DHCP
4) N/C - not used
To set the iServer to factory default
settings, slide DIP switch #2 to ON
position. Power the iServer on and
wait about 10 seconds until the
iServer fully boots up. Set the DIP
switch #2 back to OFF position (it
does not matter if the iServer is
powered ON or OFF, just make
sure that the DIP switch is set to
OFF, otherwise, every time the unit
is power-cycled the factory
settings will take over.
To enable the DHCP, slide DIP
switch #3 to ON position and
power the unit on. Besides using
DIP switch #3 you can enable
DHCP by settting the iServer’s IP
address to 0.0.0.0. An iServer
with IP address of 0.0.0.0 will
request an IP address, gateway
address, and subnet mask from
the DHCP server over the
Ethernet.