Filter
Top Products
5-18
■MARGIN (mm) / MARGIN (in)
Allows for setting of the margin size to be added to the circumference of
drawing actual length. This setting is enabled at the time of OFFSET
MODE = MARGIN setting. This setting is performed on the third
hierarchy.
<Parameter (numerical value input method)>
0 to 100 (0 to 3.9 inches) Default value = 0
■X-OFFSET (mm) / X-OFFSET (in)
Y-OFFSET (mm) / Y-OFFSET (in)
Allows for setting the offset X and Y. This setting is enabled at the time of
OFFSET MODE = VARIABLE SIZE or FIXED SIZE setting. This
setting is disabled when CENTERING = ON setting.
This setting is disabled when the drawing being produced at the center of
the origin coordinates is produced in the PAGE SIZE = REAL SCALE for
the HP-GL data only. This setting is performed on the third hierarchy.
<Parameter (numerical value input method)>
-9999.99 to 9999.99 (-393.700 to +393.700 inches) Default value = 0
Paper feed
direction
Cut position
X
Y
Drawing
Paper feed direction
Cut position
X
Y
a
a
a
Drawing
a. Set value