Filter
Top Products
2-24
When the waste bottle is nearly full with waste toner, the Waste toner
lamp will flash. Although plots can continue to be produced for a little
while longer, replace the waste bottle soon.
When the waste bottle becomes full with waste toner, the Waste toner
lamp will go out. The Error lamp will turn on and plotting will not be
possible. The following message appears on the LCD.
If the Waste toner lamp starts flashing or the message appears on the
control panel, replace the waste bottle in accordance with the procedures
outlined below.
◆ A “Waste bottle replacement” label is affixed to the side of the
waste toner bottle. Refer to this when replacing the waste
bottle.
◆ Even after the Waste toner lamp starts flashing, you should be
able to produce about 120 m of plots.
Warning
Replacing the waste toner bottle
Precautions during replacement
Do not throw waste bottles containing waste toner into
fire.
Doing so may cause an accident and fire.
Dispose of waste bottles as non-burnable garbage.
CHANGE
WA S T E BO T T L E