Filter
Top Products
6-4
EDGE CUT TIMER
When you plot data received after waiting for the data continuously,
specify the time waiting for the data so that the paper roll end is
automatically cut and the plot is produced.
◆ If plotting is not effected for a long time, the paper roll end may
be crumpled or stained by moisture or dust causing blurring or
missing of print.
Use this function to avoid such troubles.
<Parameter (choice input method)> : Default value
OFF Does not cut.
30 min Cuts after the device is left for 30 minutes.
1 hour Cuts after the device is left for 1 hour.
2 hour Cuts after the device is left for 2 hours.
4 hour Cuts after the device is left for 4 hours.
1 min Cuts after the device is left for 1 minute.
5 min Cuts after the device is left for 5 minutes.
10 min Cuts after the device is left for 10 minutes.
• Specifies the time from the completion of previous plotting to the
start of plotting of data received this time.
• Cuts about 400 mm (15.7 inches).