Filter
Top Products
14
Models H71 & H84Important: To the Operator
Adjustable Draw Handle
This unit features an adjustable draw handle to provide
the best portion control, giving a better, consistent
quality to your product and controlling costs. The draw
handle should be adjusted to provide a flow rate of 5
to 7-1/2 oz. of product by weight per 10 seconds. To
INCREASE the flow rate, turn the screw
COUNTERCLOCKWISE, and CLOCKWISE to
DECREASE the flow rate. In addition, for purposes of
SANITIZING and RINSING, the flow rate can be
increased by removing the pivot pin and placing the
restrictive bar on the TOP. When drawing product,
always have the restrictive bar on the BOTTOM.
IMPORTANT: Once the draw rate is set, tighten the
lock nut with a wrench.
Operating Screen Descriptions
When the machine is powered the system will initialize.
The screen will display “INITIALIZING”. There will be
four types of data the system will check: LANGUAGE,
SYSTEM DATA, CONFIG DATA, and LOCKOUT
DATA. During the INITIALIZING... LANGUAGE
screen, the alarm will be on. If the system data,
configuration data, or lockout history data has become
corrupt, the following screen will alert the operator that
the system settings may have been changed.
NVRAM FAULT
RESET TO DEFAULTS
PRESS SEL KEY
Once the system has initialized the SAFETY
TIMEOUT screen is displayed and the alarm is turned
on.
SAFETY TIMEOUT
ANY KEY ABORTS
This screen will be displayed, with the alarm on, for 60
seconds or until any key is pressed.
After the safety timeout has been completed, and the
power switch is OFF, one of the following screens is
displayed.
The first screen is displayed if the machine is not in a
brush clean state. If any of the requirements for a
brush clean have not been met, the time displayed will
remain at 5:00 minutes.
H71 Screen:
POWER SWITCH OFF
TIME: 4:40
HOPPER: 62.1
BARREL: 67.7
H84 Screen:
POWER SWITCH OFF
OUT TIME: 4:40 OUT
68.5 HOPPER 62.1
69.5 BARREL 67.7
When all the requirements for a brush cleaning are
met, and the five minutes expire, the screen will
change to the second screen, which is the standard
power switch OFF screen.
POWER SWITCH OFF
-- = -- = -- = -- = -- = --
UNIT CLEANED
When the power switch is set in the ON position, the
system mode of operation screen is displayed. In this
example, the machine is ON, but no mode of operation
has been selected. The second line of the display
indicates whether there is a sufficient supply of mix in
the hopper or if there is a LOW or OUT mix condition
(H84 only). The third line of the display shows the
temperature o f the mix hopper. After pressing the
AUTO key, the last line of the display shows the month
and date (MM = month, DD = day) that the machine
needs to be disassembled and brush cleaned.
H71 Screen:
MODE: OFF
HOPPER TEMP: 40.0F
BRUSH CLEAN ON: MM/DD