Filter
Top Products
23
Models H71 & H84 Operating Procedures
Install the drive shaft. Insert the drive shaft into the
freezing cylinder, hex end first, and into the rear shell
bearing until the seal fits securely over the rear shell
bearing. Be certain the drive shaft fits into the drive
coupling without binding.
Figure 3
Step 2
Install the beater assembly. First check the scraper
blades for any nicks or signs of wear. If any nicks are
present, replace both blades.
USE EXTREME CAUTION when handling
the beater assembly. The scraper blades are very
sharp and may cause injury.
If the blades are in good condition, take one of the
scraper blades and slip it under the hook at the front
of the beater. Wrap the blade around the beater,
following the helix and pushing the blade down onto
the helix as you wrap. At the back end of the beater,
slip the blade under the hook.
Figure 4
Repeat this step for the second scraper blade.
Holding the beater securely, slide the beater into the
freezing cylinder about one-third of the way in. Looking
into the freezing cylinder , align the hole at the rear of
the beater with the flats on the end of the drive shaft.
Slide the beater the remainder of the way into the
freezing cylinder and over the end of the drive shaft.
The beater should fit snugly but not so tightly that the
beater cannot be turned slightly to engage the drive
shaft.
Figure 5
Repeat Steps 1 and 2 for the other side of the freezer
on the Model H84.
Step 3
Assemble the freezer door. Place the large rubber
gasket(s) in the groove(s) on the back side of the
freezer door.
Slide the white plastic front bearing(s) onto the bearing
hub(s), making certain that the flanged end of the
bearing is resting against the freezer door. DO NOT
lubricate the gasket(s) or the front bearing(s).
Figure 6
Note: There are two gaskets and two front bearings
for the Model H84 door , one for each freezing cylinder.