Filter
Top Products
112 Installing System Components
7
Connect front panel cables to the fan controller board. See Figure 5-12.
You must route these cables properly through the tabs on the chassis to
prevent them from being pinched or crimped.
8
Connect all the cables to the backplane. See Figure 5-3 for 3.5-inch hard
drives and Figure 5-6 for 2.5-inch hard drives.
You must route these cables properly through the tabs on the chassis to
prevent them from being pinched or crimped.
9
Close the system. See "Closing the System" on page 92.
10
Replace the hard drives. See "Installing a Hard Drive Into a Hard-Drive
Carrier" on page 58.
11
Reconnect the system to its electrical outlet and turn on the system,
including any attached peripherals.
book.book Page 112 Thursday, March 4, 2010 4:38 PM