Filter
Top Products
Using the System Setup Program 49
NOTE: When Flow Control is set to Software, the Hyper Terminal on remote side is
discontinued by pressing <Ctrl><S>. But the <Ctrl><S> is also the Setup Key Stroke
for setting onboard NIC PXE Option ROM Configuration. Therefore, we suggest
users change <Ctrl><S> to <Ctrl><B> in PXE OPROM Configuration in order to avoid
that the Hyper Terminal on remote side is discontinued when pressing <Ctrl><S>.
IPMI Configuration
Redirection After BIOS POST
(Always default)
Selects the settings for the redirection. This item
disappears when Remote Access is disabled:
•
Disabled
: turns off the redirection after POST.
•
Boot Loader
: redirection is active during POST and
boot loader.
•
Always
: redirection is always active. (Some
operating systems may not work if set to
Always
)
Terminal Type
(VT100 default)
Selects the target terminal type. This item disappears
when Remote Access is disabled.
VT-UTF8 Combo Key
Support (Enabled default)
Enables or disables VT-UTF8 combination key
support for ANSI/VT100 terminals. This item
disappears when Remote Access is disabled.
Terminal Display Mode
(Normal mode default)
Selects Terminal Display Mode.
Options:
• Normal Mode
• Recorder Mode
Option Description
Status Of BMC Displays BMC status.
BMC Firmware Revision Displays BMC Firmware Revision.
View BMC System
Event Log
Selecting this option and pressing Enter, displays:
Total Number Of Entries, SEL Entry Number,
SEL Record ID, SEL Record Type,
Event Time Stamp, Generator ID, Event Message
Format Version, Event Sensor Type, Event Sensor
Number, Event Dir Type, and Event Data.
Option Description
book.book Page 49 Thursday, March 4, 2010 4:38 PM