Filter
Top Products
28
longitude, Time Zone and select the Daylight Savings Time on or off.
• Press UP or DOWN to adjust the latitude. Press and hold either button for quick
digits advance.
• Press SET to confirm the selection.
• Continue setting the longitude using the same technique.
• Set the Time Zone by pressing UP or DOWN to adjust the time in 30 min
intervals. Press and hold either button for quick digits advance.
• Press SET to confirm selection.
If the USR was selected as a city code or your city is located in the Daylight Savings
zone you would need to set the Daylight Saving Time Option:
• Press UP or DOWN to enable of disable the DST option. Press and hold either
button for quick digits advance.
• Press SET to confirm selection.
• Continue setting the year, month, day, calendar format (day/month or
month/day), time format (12 or 24 hours), local hour and minutes, using the
same technique.
After programming is complete the display will return to the default Clock and Alarm
Mode.
Note: Press and hold SET anytime during the setup to return to normal Clock and Alarm
Mode and all previous settings will be cancelled.
Different Clock and Calendar Displays
In the Clock and Alarm Mode press SET selecting either:
• Hour and Minutes with the Day of the week
• Hour and Minutes for UTC (Coordinated Universal Time)
• Hour and Minutes with the City abbreviation
• Hour and Minutes with the Seconds
• Month with the day and a year or Day with Month and a year.
Enabling or Disabling the Time Alarms
• Press the ALARM/CHART to display the Weekday Alarm or Ice Warning
Alarm (Pre-Alarm) time. If these alarms are not set, the abbreviation OFF will
be displayed.
• To enable or disable any of these alarms, press UP or DOWN.
Note: Press SET anytime during alarm selection mode to return to the default clock
display.
Programming Time Alarms
• In the Clock and Alarm Mode, press the
ALARM/CHART selecting the desired
alarm.
• Press and hold ALARM/CHART button until the hour digit will flash