Filter
Top Products
34
Disabling Temperature Alarm(s)
In the Temperature & Humidity Mode press the ALARM/CHART to disable the
alarm(s).
Viewing the Max/Min Channel Temperature and Humidity
In the Temperature & Humidity Mode press the MEMORY button to recall a current
temperature and humidity, minimum temperature and humidity or maximum temperature
and humidity at the remote location.
Resetting the Remote Temperature and Humidity Memory
In the Temperature and Humidity Mode, press and hold MEMORY button to clear
memory for all channels.
Remote Sensor Status
The wave icon above the current channel display shows the connection status of the
corresponding remote sensor:
Icon Status
Searching for the signals from the remote sensor
Corresponding remote sensor signal received successfully
No signals received for over 15 minutes
All Remote Sensor Signals Search Activation
The main unit can be manually activated to search for the signals from all remote sensors.
Press and hold DOWN button to enable the search.
Rain Mode
The main unit records the total amount of the rainfall for the last hour, 24 hours, past day,
past week and the past month. The rainfall can be displayed in mm or inches.
There is a daily rainfall alert that can be programmed in the unit if the daily rainfall
exceeds a pre-programmed limit.
Accessing Rain Mode
From the main unit: Press UP or DOWN until the RAIN icon
on the display starts
flashing.From the remote control: Press
.