Filter
Top Products
31
dates.
Accessing Sunrise/Sunset Mode
From the main unit: Press UP or DOWN until the sunrise and sunset icons
on the lower left of the display will start flashing.
From the remote control: Press
.
Programming the Location Data
• In Sunrise/Sunset Mode, press and hold SET to enter the location programming
mode until the city code in the Time and Alarm display will flash.
• Select the city code closest to your area by pressing the UP or DOWN. Refer to
P.40 for a list of available codes. The corresponding longitude and latitude will
be displayed in Sunrise/Sunset window along with the city code.
• If you wish to enter the geographical coordinates yourself, select the “USR” as
the city code.
• Press SET to confirm your selection and enter into the geographical coordinates
programming mode
Set Degree of Latitude
• Press UP or DOWN to adjust the digits. Press and hold either button for fast
advance.
• Press SET to confirm your selection.
• Repeat above procedure to set latitude and longitude minutes, longitude degrees,
time zone, and DST selection.
• Once programming is completed, the display will return to the Sunrise/Sunset
Mode.
Note: Press and hold SET anytime during the setup to return to normal Clock and Alarm
Mode. All settings will be cancelled.
Viewing the Location Data
In Sunrise/Sunset Mode press SET button to select between the time and sunrise/ sunset
times mode display, calendar and sunrise/ sunset times display and a calendar and
longitude/ latitude display.
Viewing Sunrise/Sunset Times for Different Dates
• In Sunrise/Sunset Mode, press the MEMORY button until the date will flash.
• Press UP or DOWN to adjust the date. Press and hold either button for fast
digits advance.