Filter
Top Products
23
MEMORY OPERATION
5
■ General description
The receiver has 1100 memory channels including 100 scan
edge memory channels (50 pairs) for storage of often-used
frequencies. And a total of 21 memory banks, A to H, J to R,
T, U, W and Y are available for storing groups of frequencies,
etc. Up to 100 channels can be assigned to a bank.
DD
Memory channel contents
The following information can be programmed into memory
channels:
• Operating frequency (p. 13)
• Receive mode (p. 13)
•Tuning step (p. 12)
•Attenuator ON/OFF (p. 15)
• IF filter selection (p. 18)
• Duplex direction (DUP+ or DUP–) with an offset fre-
quency (p. 19)
• Squelch control system ON/OFF and its frequency or
code (pgs. 39, 41, 43, 45)
• Scan skip information (p. 36), etc.
■ Memory channel selection
q Push the desired band’s [VFO/MR•S.MW] once or twice
to select memory mode
.
•“M” indicator appears.
w
Rotate the same band’s [DIAL] to select the desired mem-
ory channel.
• Programmed memory channels only can be selected.
“!” indicator appears when
memory mode is selected
[VFO/MR•S.MW]
If memory banks or weather channels* mode appears at
step q, push [MHz•TS] and rotate [DIAL] to select
“bAnk --,” then push any keys for the main band or any of
the shared keys below the display to return to channel se-
lection.
*Available for USA/CANADA versions only.