Filter
Top Products
39
POCKET BEEP AND TONE SQUELCH
8
This function uses subaudible tones for calling and can be
used as a “common pager” to inform you that someone has
called while you were away from the receiver.
D Waiting for a call from a specific station
q Set the operating frequency in FM mode.
w Push
[SET•
SKIP
]
to enter set mode in the main band.
e Push
[SET•
SKIP
]
or [ATT•PRIO] several times until “Ct”
(when selecting the tone squelch) or “dt”(when selecting
the DTCS squelch) appears.
r Rotate the main band’s [DIAL] to select the desired tone
frequency or DTCS code.
t When operating the pocket beep function with DTCS code
squelch, push
[SET•SKIP] once then r
otate the main
band’s [DIAL] to select the DTCS polarity.
y Push any key for the main band to exit set mode
.
u Push and hold [MONI•T/T-SCAN] for 1 sec. to enter tone
squelch selection mode, then rotate the main band’s
[DIAL] until “S ” or “ S” appears to turn the
pocket beep function ON with tone squelch or DTCS
squelch, respectively.
[MONI•T/T-SCAN]
[DIAL]
Appears when the pocket beep
with tone squelch is turned ON.
Appears when the pocket beep
with DTCS squelch is turned ON.
DTCS polarity setting
[DIAL]
Tone squelch frequency setting DTCS code setting
[ATT•PRIO]
[SET•SKIP]
■ Pocket beep operation