Filter
Top Products
5
MEMORY OPERATION
29
Contents of programmed memories can be cleared (erased),
if desired.
q Push [VFO/MR•S.MW] to select VFO mode
in the main
band.
w Push the same band’s [VFO/MR•S.MW] for 1 sec. to enter
select memory write mode
.
•“!” indicator and the memory channel number blink.
e Rotate the same band’s [DIAL] to select the memory
channel to be cleared.
• Memory channels not yet programmed are blank.
r Push [SET•SKIP] three times to select “CLEAR,” then
push and hold [VFO/MR•S.MW] for 1 sec.
•3 beeps sound.
• The cleared channel display changes to blank.
•“!” and the memory channel number blink continuously.
t Push the same band’s [MAIN] or [MHz•TS] to exit select
memory write mode, or repeat steps e and r to clear an-
other channel.
y Push the same band’s [VFO/MR•S.MW] to return to VFO
mode.
☞NOTE: Be careful!— the contents of cleared memories
CANNOT be recalled.
[EXAMPLE]: Clearing memory channel 20.
Push to select VFO. Rotate for selecting memory channel.Push for 1 sec.
S.MW
VFO/MR
S.MW
VFO/MR
S.MW
VFO/MR
Push any switch for main band
other than , then push to return to VFO.
S.MW
VFO/MR
S.MW
VFO/MR
Push three times, then push for 1 sec.
SET
SKIP
Beep
Beep
Beep
■ Memory clearing