Filter
Top Products
37
6
SCAN OPERATION
The scan resume condition can be selected a timed timer or
pause scan. The selected resume condition is also used for
priority watch. (p. 38)
q Push
[MAIN•AGC] (or [MAIN•NB])
to select the desired
band (left or right) as the main band.
w Push
[SET•
SKIP
]
to enter set mode.
e Push
[SET•
SKIP
]
or [ATT•PRIO] several times until “SCt”
or “SCP” appears.
r Rotate the main band’s [DIAL] to set the desired timer:
• “SCP-2” : Scan pauses until the signal disappears and then
resumes 2 sec. later.
• “SCt-15” : Scan pauses 15 sec. while receiving a signal.
• “SCt-10” : Scan pauses 10 sec. while receiving a signal.
• “SCt-5” : Scan pauses 5 sec. while receiving a signal.
t Push any key for the main band to exit set mode.
[DIAL]
[ATT•PRIO]
[SET•SKIP]
[MAIN•AGC]
[MAIN•NB]
[SET•SKIP]
The display shows that the
scan will resume 15 sec. after it
stops.
■ Scan resume condition
USING
SET MODE