Filter
Top Products
47
9
DIGITAL MODE OPERATION
Sets your own call sign for digital call sign squelch operation.
Up to 8 characters are programmable.
q Push [SET•SKIP] to enter set mode
.
w Push
[SET•SKIP]
or [ATT•PRIO] several times until “OPt”
appears, then rotate main band’s [DIAL] to select “On.”
e Push
[SET•SKIP]
or [ATT•PRIO] several times until “
CAL
”
appears.
• The 1st digit blinks.
r Rotate main band’s [DIAL] to select the desired character
or code.
• Push [MODE•SCAN] or [MONI•T/T-SCAN] to move the cursor
to right or left, respectively.
t Push [MODE•SCAN] to select 2nd digit, then rotate main
band’s [DIAL] to select the desired character or code.
• 2nd digit blinks (1st digit stop blinking).
• Repeat this step for programming your own call sign.
y Push any key for the main band to exit set mode.
[DIAL]
[VFO/MR•S.MW]
[SET•SKIP]
■ Call sign programming (for DV mode) [
If the wrong call sign or code is programmed, the digital
squelch will not open. Please make sure of the correct call
sign or code before programming.