Filter
Top Products
10
4. Use the
UP and DOWN keys to input the number of gallons the tank
will hold and press
MENU. Repeat steps 3 and 4 for each additional
tank. After all tanks have been set up, you will be directed to the main
display.
Boat Setup Reset
If you want to access the Setup screen (Boat Setup) after an engine-
tank configuration has been chosen you will have to reset the
configuration to default settings.
To reset engine tank configuration:
1. Press MENU, highlight SYSTEM SETUP and press MENU.
2. Choose
ENG/TANK and press MENU twice. The following message will
appear: Hit menu to reset Eng/Tnk.
3. Press
MENU. The Setup screen will appear with Boat Setup
highlighted.
EP-90R Pressure Configuration
Your EP-90R Pressure Sensor can be configured to measure the
following data types: Pitot Speed (PTT:S), Water Pressure (WTR:P),
Engine Oil Pressure (Eng:O:P), Fuel Pressure (FUL:P), Boost Pressure
(BST:P), Transmission Oil Pressure (Trn:O:P) and Atmospheric
Pressure (ATM:P).
To configure the EP-90R:
1. Press MENU, select SYSTEM SETUP and press MENU.
2. Highlight
BUS DEVICES and press MENU. Select an unconfigured
pressure sensor (
UNCFG PRES) and press MENU. The following message
will appear: Hit Menu to Cfg Pres Snsr.
3. Press
MENU, then select PTT:S (Pitot Speed), WTR:P (Engine Water
Pressure),
ENG:O:P (Engine Oil Pressure), FUL:P (Fuel Pressure), BST:P
(Boost Pressure), TRN:O:P (Transmission Oil Pressure) or ATM:P
(Atmospheric Pressure) and press MENU. The Select Engine menu will
appear with up to three options. (If your unit is set to a single-tank
configuration, or if you chose Pitot Speed or Atmospheric Pressure, you
will be directed to the Bus Devices list.)
4. Select the desired tank and press
MENU. You will be taken back to
the Bus Devices list.