Filter
Top Products
24
Engine & Tank Configuration
The Engine-Tank configuration menu is located below the NMEA 2000
Devices list, but will only be accessible if engine- or fuel-related devices
are on the network.
When choosing an engine-tank configuration you will use the Tank
Select menu, Tank Size dialog box and Set Configuration button.
Bus Setup highlighted on the NMEA 2000 menu (left). Bus Setup
selected on Networking menu (right).
Setting Engine-Tank Configuration:
1. Press MENU twice, highlight NMEA 2000 or NETWORKING and press
ENTER.
2. The NMEA 2000 menu will appear with five options: Bus Setup,
Fuel Management, NMEA 2000 Alarms, Waypoint Sharing and
Backlight Synchronization. Choose
BUS SETUP and press ENTER.
3. Select
ENGINE & TANK CONFIG and press ENTER, which will open the
Engine & Tank Configuration menu with the following configuration
options: 1 Engine/1 Tank, 1 Engine/2 Tanks, 2 Engines/1 Tank, 2
Engines/2 Tanks, 3 Engines/1 Tank, 3 Engine/3 Tanks and
Unconfigured Bus.
4. Choose the configuration that matches the number of engines and
tanks on your vessel and press
ENTER.
5. Highlight
TANK SELECT and press ENTER, which will open the Tank
Select menu.
6. Select the tank you want to set up and press
ENTER. Highlight the
Tank Size dialog box and press
ENTER.
7. Input the capacity (gallons) of the tank you chose from the Tank
Select menu and press
ENTER.
8. Repeat Steps 5-7 for each remaining tank.