Filter
Top Products
23
Display Unit: EP-90R
Pressure Configuration
This section will show you how to use an EP-90R Pressure Sensor with
a display unit.
The LMS-525cDF is one of many Lowrance display units that may be
used with the EP-90R Pressure Sensor.
NOTE:
Your unit may have a NMEA 2000 menu or a Networking menu,
depending on the software version installed in your unit. Both
menus allow you to perform the same NMEA 2000-related
functions.
Bus Setup
Selecting Bus Setup from the NMEA 2000 or Networking menu will
open the Bus Configuration menu, giving you access to the Engine-
Tank Configuration menu and the NMEA 2000 Devices list. The list,
located in the top half of the Bus Configuration menu, shows all devices
connected to the network. The Engine-Tank Configuration menu is
located in the bottom half of the Bus Configuration menu.
NOTE:
Some of the menus shown in this section may differ slightly from
the menus in your display unit, but your unit will perform the same
functions in a similar manner.