Filter
Top Products
16
5. After all tanks on your vessel have been set up, press
EXIT repeatedly
to return to the main display.
Boat Setup Reset
If you want to access the Setup screen (Boat Setup) after an engine-
tank configuration has been chosen you will have to reset the
configuration to default settings.
To reset engine-tank configuration:
1. Press MENU, highlight SYSTEM SETUP and press ENTER.
2. Choose
ENG/TANK CFG and press ENTER twice. The following message
will appear: Press ENTER to reset Eng/Tnk Cfg.
3. Press
MENU. The Setup Menu will appear with Boat Setup
highlighted.
EP-90R Pressure Configuration
Your EP-90R Pressure Sensor can be configured to monitor the
following data: Pitot Tube, Engine Boost Pressure, Engine Oil
Pressure, Engine Water Pressure, Fuel Pressure, Transmission Oil
Pressure and Atmospheric Pressure.
To configure the EP-90R:
1. Press MENU, select SYSTEM SETUP and press ENTER.
2. Highlight
BUS DEVICES and press ENTER. Select an unconfigured
pressure sensor and press
ENTER. The following message will appear:
Press Enter to Configure Pressure Snsr.
3. Select
PITOT SPEED, ENG BST PRESS, ENG OIL PRESS, ENG WTR PRESS, FUEL
PRESSURE, TRNS OIL PRESS or ATM PRESSURE and press ENTER.
4. The Select Engine menu will appear with up to three options. (If
your unit is set to a single-engine configuration, or if you chose Pitot
Tube or Atmospheric Pressure, you will be taken back to the Bus
Devices list.)
5. Select the desired engine and press
ENTER. You will be directed to
the Bus Devices list.
To unconfigure the EP-90R:
1. Press MENU, select SYSTEM SETUP and press ENTER.
2. Highlight
BUS DEVICES and press ENTER. Select a configured pressure
sensor and press
ENTER.
3. Highlight
UNCONFIGURE and press ENTER. The following message will
appear: Press Enter to Unconfig Device Name.