Filter
Top Products
COMMUNICATION SPECIFICATIONS
27
Device
No.
Signal Description
RX10
RX11
RX12
RX13
RX14
RX15
RX16
RX17
RX18
RX19
Reserved Reserved for the system.
RX1A Error status flag Switched on when an inverter error occurs (protective function is activated).
RX1B Remote station ready
Switched on when the inverter goes into the ready status on completion of initial setting
after power-on or hardware reset.
(Used as an interlock for read/write from/to the master station.)
Switched off when an inverter error occurs (protective function is activated).
Note: With Pr. 190 to Pr. 192 (output terminal function selection), you can set the output signals of device No.s RX2,
RX6, RX7. For full information, refer to the inverter manual.