Index
NI 5911 User Manual I-2
©
National Instruments Corporation
SMB connector, 1-1
conventions used in manual, v
customer communication, C-1 to C-2
D
dead time, in multiple record acquisition, 2-13
differential input, 2-2 to 2-4
grounding considerations, 2-2 to 2-3
input bias, 2-4
input impedance, 2-3 to 2-4
input protection, 2-4
input ranges, 2-3
noise-free signal measurement
(figure), 2-2
digitizers, B-1 to B-7
ADC resolution, B-4
analog bandwidth, B-2
making accurate measurements,
B-4 to B-7
dynamic range of 8-bit ADC
(figure), B-5
general signal shape, B-6 to B-7
input coupling, B-7
input frequency, B-6
peak-to-peak value, B-4 to B-5
source impedance, B-6
trigger hold-off, B-7
Nyquist theorem, B-1
record length, B-4
sample rate, B-2 to B-3
triggering options, B-4
vertical sensitivity, B-3
DIN connector, 1-1
location on front panel (figure), 1-2
distortion specifications, A-5
dynamic range specifications, A-5
E
electronic support services, C-1 to C-2
e-mail support, C-2
EMC compliance, A-8
errors during acquisition, 2-14
F
fax and telephone support numbers, C-2
Fax-on-Demand support, C-2
filtering specifications, A-4
flexible resolution mode, 2-5 to 2-6
available sampling rates (table), 2-6
FTP support, C-1
G
grounding considerations, 2-2 to 2-3
H
hardware overview, 2-1 to 2-16. See also
specifications.
AC coupling, 2-4
acquisition system, 2-6 to 2-16
calibration, 2-7 to 2-8
errors during acquisition, 2-14
memory, 2-12
multiple record, 2-13 to 2-14
PFI lines, 2-15
RTSI bus trigger and clock lines,
2-14 to 2-15
synchronization, 2-15 to 2-16
triggering and arming, 2-8 to 2-12
block diagram of NI 5911, 2-1
differential input, 2-2 to 2-4
grounding considerations, 2-2 to 2-3
input bias, 2-4
input impedance, 2-3 to 2-4
input protection, 2-4
input ranges, 2-3
noise-free signal measurement
(figure), 2-2
CBIHWum.book Page 2 Thursday, October 29, 1998 1:56 PM