Filter
Top Products
Index
NI 5911 User Manual I-4
©
National Instruments Corporation
power requirement specifications, A-7
pulse train signal, difficult (figure), B-6
R
Real Time sampling, 2-6
record length, B-4
Repetitive (RIS) sampling, 2-6
RTSI bus trigger and clock lines
purpose and use, 2-14 to 2-15
synchronization, 2-16
S
sample rate
digitizers, B-2 to B-3
flexible resolution mode sampling rates
(table), 2-6
signal shape, general, 2-6
SMB connector, 1-1
location on front panel (figure), 1-2
source impedance, B-6
specifications, A-1 to A-8
acquisition characteristics, A-3 to A-5
accuracy, A-3
common-mode characteristics, A-3
distortion, A-5
dynamic range, A-5
filtering, A-4
acquisition modes, A-7 to A-8
calibration, A-8
EMC compliance, A-8
operating environment, A-8
physical, A-8
power requirements, A-7
storage environment, A-8
acquisition system, A-1 to A-2
timebase system, A-6
triggering systems, A-6 to A-7
storage environment specifications, A-8
synchronization, 2-15 to 2-16
T
technical support, C-1 to C-2
telephone and fax support numbers, C-2
timebase system specifications, A-6
triggering and arming, 2-8 to 2-12
analog trigger circuit, 2-9 to 2-11
above-level analog triggering mode
(figure), 2-10
below-level analog triggering mode
(figure), 2-10
high-hysteresis analog triggering
mode (figure), 2-11
low-hysteresis analog triggering
mode (figure), 2-11
specifications, A-6 to A-7
timing with hold-off enabled
(figure), 2-12
trigger hold-off, 2-11 to 2-12, B-7
trigger sources (figure), 2-9
triggering options, for digitizers, B-4
V
vertical sensitivity
digitizers, B-3
specifications, A-2
VirtualBench-Scope soft front panel,
1-2 to 1-6
Acquire tab (figure), 1-6
acquiring data, 1-5 to 1-6
features, 1-3 to 1-4
front panel (figure), 1-3
CBIHWum.book Page 4 Thursday, October 29, 1998 1:56 PM